How to start WIZwiki-W7500 Board
To install the serial driver
Test Sequence 1. Connect Ethernet cable, USB cable to WIZwiki-W7500. If you have a SD card, insert the SD card. 2. Run the Device Manager in Control panel and check which COM port is allocated to the USB port on WIZwiki-W7500. 3. Press Reset SW, then LED ‘D4’ on WIZwiki-W7500 will be turned on. If D4 is turned off, then press the Reset SW again.
<Serial setting> Baud rate : 115200 Data bits : 8 Parity : None Stop bits : 1 Flow : None
If you have a SD card, the state of D4 will turn like this: White => White Blink => Yellow The following message prints out to the serial port.
If you do not have a SD card, D4 of the state will turn like this: White => White Blink => Red The following message prints out to the serial port.
5. Run a command window and proceed with the ping test to WIZwiki-W7500. 6. WIZwiki-W7500 operates as loopback server. 7. Make proceed with the ping test or loopback test with an IP of 192.168.077.009 on WIZwiki-W7500.
Necessarily, IP of the PC must also be set to 192.168.077.XXX.
8. If you can do everything well, then your WIZwiki-W7500 doesn’t have any problem.